|
Post by account_disabled on Dec 12, 2017 2:45:08 GMT -5
Hello,
I have an Enerpac Turbo II foot actuated pump(air over hydraulic) that I use with a 15 ton cylinder on my bender. The other night I was running it to make a 66 deg bend in a piece of 1.5" HRS round. It always has a fairly low cycle time on this material, but during this run, it stopped at about 20 deg, and would not bend any farther. My initial thought was I need some more fluid. Bought some fluid, and filled the pump. Didn't seem to be low necessarily, but it does mist oil when using it
Please help
Thanks
I didn't find the right solution from the Internet
References:
www.practicalmachinist.com/vb/general/hydraulic-pump-problem
Technology Explainer Video
|
|